Bronkhorst

Flow control in catalyst research

February 26, 2020 Yann Le-Guenniou
Catalysis

In this blog, I would like to share an application at an energy research organization, investigating a catalysed chemical reaction of a mixture of hydrocarbon compounds. The main challenge here was how to deal with a high temperature and high pressure. Happily we were able to offer the customer a solid working solution containing a Coriolis based mass flow meter with a high pressure pump. 

What are catalysts?

Catalysts are being used to accelerate a chemical reaction without actually being consumed. So a small amount of catalyst is sufficient to obtain a large amount of reaction products.

Solid catalysts are often small, highly porous particles, with a large internal surface area in a small volume. This internal surface contains active sites on which the reaction takes place. Gaseous or liquid chemicals diffuse into the pores of these particles, and react at the catalytically active sites to reaction products that diffuse out of the particle. Often, these reactions occur at extreme process conditions.

What kind of liquid flow meters can be used here?

A simple and reliable solution had to be found to inject a liquid flow at a high pressure. This injection has to take place at 30 to 60 bars, and needs to result in a stable flow without pulsation. Furthermore, the liquid flow needs to be controlled accurately, and during the process it has to be known how much liquid actually has been injected.  For this, a solution of a liquid mass flow meter with high pressure pump is a good choice.

catalysis at high pressure
Catalysis at high pressure

A combination of liquid mass flow meter with high pressure pump

The solution comprises a Coriolis liquid mass flow meter that controls a (HPLC) high pressure piston pump at the inlet side of the reactor and an independently operating back pressure controller at the outlet side. The tested Coriolis mass flow meter (mini CORI-FLOW ML120) has proven to be a very stable and accurate mass flow meter. The WADose HPLC pump gives a very stable flow without pulsation. The combination of an high pressure pump and mass flow meter works as a mass flow controller. The control valve of the mass flow meter is not necessary, as the pump is used as an actuator.

The pump can handle a liquid viscosity of max. 40 mPa.s at the upstream side. The maximum operating temperature is 70 °C. The temperature of the furnace that contains the reactor tube with small catalyst particles is much higher. The pressure at the reactor tube outlet has to remain at a high value. Beyond the outlet there is a cold trap for water or oil condensation, a back pressure controller with control valve that can handle pressure differences up to 400 bars and an exhaust to atmospheric pressure.

The pressure controller can handle gas and liquid in a very stable controlled flow. Especially at very small flow rates, this pressure controller has a much better control performance than a mechanical pressure reducer. The exhaust is used to remove gas that has been produced at the reaction.
The pump has three control modes:

  1. pressure
  2. volumetric (only the speed of the piston is controlled)
  3. and mass flow
The latter is a special feature that can be offered, and is convenient from a chemist’s point of view. As the flow can be controlled directly, the exact number of moles injected to the process is known.

Read the applicatoin note for the complete solution or contact us for more information.

Read application note Contact for information
High Pressure pump with mass flow meter
Liquid Mass Flow Meter with High Pressure Pump

Bronkhorst High-Tech B.V.

Nijverheidsstraat 1A
NL-7261 AK Ruurlo (NL)
Tel. +31 573 45 88 00
[email protected]

Copyright © 2020 Bronkhorst. All rights reserved.     Sitemap     Disclaimer     Privacy note