Bronkhorst

IN-LINE Filters

  • Filters for Mass Flow Meters / Controllers
  • For increasing the MTBF (Mean Time Between Failure)
  • contains a 316L sintered metal filter cartridge
  • Housing: AISI 316
  • O-rings: Viton; optional EPDM and FFKM (Kalrez)

afbeelding

Increase the MTBF of your flow meter / controller

Inherent to its construction, a thermal mass flow meter or controller for gases is sensitive to contamination. To increase the MTBF (Mean Time Between Failure) it is important to make sure that the gas entering the instrument is clean. The IN-LINE Filter Assembly, screwed into the inlet of the instrument, provides this service. It contains a 316L sintered metal filter cartridge that is suitable for general purpose filtration and can be cleaned with a suitable solvent. If the gas contains a large particulate content, we advise the use of a pre-filter.

 

Filter selection

Choose a low-flow or medium-flow style filter for instruments with ¼” female thread at the inlet; the high-flow filter is suitable for mounting into instruments with ½” female thread; the ultra-low-flow filters have ⅛" connections. In principle select finest porosity with low ΔP; preferably ΔP not higher than 250 to 500 mbar, and porosity not bigger than 5 μm. The ΔP across the IN-LINE filter can be calculated with the help of our online calculation tool FLUIDAT on the Net.

Downloads

Brochures
IN-LINE Filters brochure

Dimensional drawings
Dimensional Drawing M-410
Dimensional Drawing M-411
Dimensional Drawing M-412
Dimensional Drawing M-413


Bronkhorst High-Tech B.V.

Nijverheidsstraat 1A
NL-7261 AK Ruurlo (NL)
Tel. +31 573 45 88 00
[email protected]

Copyright © 2018 Bronkhorst. All rights reserved.     Sitemap     Disclaimer     Privacy note