Low-Flow Magnetic Inductive Flow meters for water-like liquids

  • Compact, weatherproof (IP65) design
  • No moving parts (no mechanical wear)
  • Interference free operation
  • Independence to inlet/outlet pipework
  • Fast response
  • Free pipe cross section: low ΔP, insensitive to contamination
  • Cost-optimized (plastic) model
  お見積り依頼 Downloads Buy now Datasheet

Electromagnetic flow meters for low flow rates of water and aqueous solutions

MAG-VIEW instruments are electromagnetic inductive flow meters for electrically conductive liquids with a minimum conductivity of 20 μS/cm. The compact, weatherproof (IP65) flow meters do not contain any moving parts, cause virtually no pressure loss and can be mounted in any position, requiring no straight inlet or outlet runs.

MAG-VIEW flow meter model MVM-050-QA is a cost-efficient instrument with a DN15 PVDF measuring tube for flow rates of 2,5…50 l/min, suited for operating pressures up to 10 bar(g). The analog and pulse output signals of the instrument are proportional to the flow.

Technical specifications

Measurement / control system
流量レンジ2,5 … 50 l/min
(max. flow 60 l/min)
Volume flow accuracy± 1 % RD
(incl. factory calibration certificate; test conditions: water 23°C)
Repeatability1 % FS
Turndown ratio1:20 (5…100%)
Signal output starting from~ 1 l/min
MediaWater and other conductive liquids
(minimum conductivity of 20 μS/cm)
Response time (sensor)< 100 msec
Operating temperatureMedium -10…60°C,
Ambient 5…60°C, not freezing
MountingAny position, attitude insensitive
Flow indicationblinking green LED
Mechanical parts
Material (wetted parts)Electrodes and grounding rings: Stainless Steel 316L
Measuring pipe: PVDF
Process connections: PVDF
Process connections¾" BSP male thread
Ingress protectionIP65
Nominal pressuremax. 10 bar at 20°C, 8 bar at 40°C, 6 bar at 60°C
Electrical properties
Power supply12 … 24 Vdc ±10 %
Max. power consumption3,6 W
Analog output4 … 20 mA
Frequency outputPulse rate / K-factor : 400 pulses/l
Resolution : 2,5 ml/pulse
Signal shape : Push-Pull
Signal current : max. 25 mA
Electrical protection measuresShort-circuit proof,
protected against polarity reversal
Electrical connection4-pin-plug M12x1
Electrical connection
Control valve options
External actuator options to be connected to the controller
Certification for hazardous areas
Approvals / certificates

Technical specifications subject to change without notice.

For dimensional drawings and hook-up diagrams please visit the product page on our website


MAG-VIEW Brochure


Tel.  03-3645-1371

sales◎   ◎を@に置き換えて下さい

Copyright © 2024 Bronkhorst. All rights reserved.     サイトマップ     免責事項     プライバシーポリシー