Mass Flow Meter for gases with integrated display

  • Direct thermal mass flow measurement
  • High accuracy
  • 10 pre-installed gases
  • Bright, graphical OLED display
  • Digital or analog output; alarm and counter functions
  Get a quote Downloads Buy now Support

Gas Mass Flow Meters with integrated display

MASS-VIEW® model MV-106 Direct Thermal Mass Flow Meters (MFMs) are suited for precise measurement of flow ranges between 0,4…20 ln/min and 2…200 ln/min at operating pressures up to 10 bar(g). The MFM has an integrated graphical OLED display, clearly visible at wide angles, which allows reading of actual flow (value and a bar graph), total flow and type of gas.

The display features easy set up via a user-friendly menu, using a 4-way navigation push button. The pre-installed gases eliminate the need to recalibrate for different gases and therefore reduce the cost of ownership. Additional features & functions include a variety of alarm and counter functions, an analog output signal, digital interfaces and two relay contacts.

The MASS-VIEW® series provides modern, novel and economical alternative to variable area meters (VA meters), also known as purge meters. Unlike conventional VA meters these new flow meters measure mass flow instead of volume flow.

Technical specifications

Measurement system
Flow range, based on N2
(intermediate ranges available)
min. 0,4…20 ln/min
max. 2…200 ln/min
Accuracy ± 2% Rd for flow > 50% of max. capacity;
± (1% Rd + 0,5% FS) on lower flows
Repeatability < 0,2% FS typical
Pre-installed gases Air, Ar, N2, O2, CO2, CH4, C3H8, N2O, CO and C4H10 
Standard calibration gas Air, other gases are converted using our Fluidat® conversion model which will introduce extra inaccuracy
Turndown up to 1 : 100
Operating pressure 0 ... 10 bar(g) / 0 ... 150 psi(g)
Pressure coefficient ± 0,2% Rd/bar typical at Air
Operating temperature 0 ... 50°C (32 ... 122°F)
Temperature coefficient Zero: <0,1% FS/°C, Span: <0,2% Rd/°C
Response time sensor (t63%) 0,9 sec.
Leak integrity tested < 2 x 10-9 mbar l/s He
Attitude sensitivity < 0,1% FS
Mechanical parts
Material (wetted parts) Aluminium
Test pressure 21 bar(a) / 300 psi(a)
Process connections G 1/4” BSPP female thread
(compression fittings optional)
Seals Viton®
Weight 0,7 kg
Ingress protection IP40
Electrical specifications
Power supply +15…24 Vdc (+/- 10%)
Power consumption approx.135 mA
Min. and max. relay contacts switching current 0,5 A, 24 Vdc,
one side grounded (0 Vdc power)
Analog output 0...5 Vdc
Digital communication RS232 / RS485 (Modbus RTU/ASCII)
Electrical connection 8-pin RJ-45 modular jack

- Technical specifications subject to change without notice.

For dimensional drawings and hook-up diagrams please visit the productpage on our website


MASS-VIEW Brochure

Quick installation guide

Hook-up diagrams
Hook-up diagrams
Modbus-RTU ASCII, RS-232 interface

Dimensional drawing
Dimensional drawing MV-1XX and MV-3XX

Bronkhorst High-Tech B.V.

Nijverheidsstraat 1A
NL-7261 AK Ruurlo (NL)
Tel. +31 573 45 88 00
[email protected]

Copyright © 2019 Bronkhorst. All rights reserved.     Sitemap     Disclaimer     Privacy note