Low-Flow Magnetic Inductive Flow meters for water-like liquids

  • Compact, weatherproof (IP65) design
  • No moving parts (no mechanical wear)
  • Interference free operation
  • Independence to inlet/outlet pipework
  • Fast response
  • Free pipe cross section: low ΔP, insensitive to contamination
  Get a quote Downloads Buy now Support

Electromagnetic flow meters for low flow rates of water and aqueous solutions

MAG-VIEW instruments are electromagnetic inductive flow meters for electrically conductive liquids with a minimum conductivity of 50 μS/cm. The compact, weatherproof (IP65) flow meters do not contain any moving parts, cause virtually no pressure loss and can be mounted in any position, requiring no straight inlet or outlet runs.

MAG-VIEW flow meter model MVM-250-PN has a nominal diameter of DN20 for flow rates of 5...250 l/min, suited for operating pressures up to 16 bar(g). The pulse output of the instrument is proportional to the flow.

Technical specifications

Measurement / control system
Flow rates5 … 250 l/min
Volume flow accuracy± 1,5 % RD + ±0,3% FS
(incl. factory calibration certificate; test conditions: water 23°C)
Turndown ratio1:50
Reproducibility1 % FS
Signal output starting from~ 4 l/min
MediaWater and other conductive liquids
(minimum conductivity of 50 μS/cm)
Response time (sensor)< 500 msec
Medium temperature-20 … 90 °C
MountingAny position, attitude insensitive
Flow indicationgreen LED, flow proportional flashing
Mechanical parts
Material (wetted parts)Electrodes: Stainless Steel 1.4571
Process connections: Stainless Steel 1.4571
Measuring pipe: PEEK-GF30
Gasket: EPDM
HousingAluminium pressure diecasted
Process connections1" BSP male thread
Ingress protectionIP65
Nominal pressurePN16
Electrical properties
Power supply24 Vdc ±10 %
Max. power consumption150 mA
Frequency outputPulse rate / K-factor : 100 pulses/l
Resolution : 10 ml/pulse
Signal shape : Square wave signal - duty cycle 50:50
Push-Pull - NPN open collector [o.c.] - PNP o.c.
Signal current : max. 100 mA, current limited
Electrical connection5-pin-plug M12x1
Electrical connection
Control valve options
External actuator options to be connected to the controller
Ex-proof specifications
Approvals / certificates

Technical specifications subject to change without notice.

* Test conditions
  Water 23°C

For dimensional drawings and hook-up diagrams please visit the product page on our website


MAG-VIEW Brochure

Bronkhorst USA LLC

57 South Commerce Way
Suite 120
USA - Bethlehem, PA 18017 
Tel.  +1-610-866-6750

        Social Responsibility
Copyright © 2021 Bronkhorst. All rights reserved.     Sitemap     Disclaimer     Privacy note