Bronkhorst

PROFIBUS DP Interface

Bronkhorst® Mass Flow Meters/Controllers can be directly used as PROFIBUS DP slaves. By using the SPC3-Asic of Siemens Baud rates of up to 12 MBaud can be achieved.

afbeelding
EL-FLOW Select Mass Flow Controller (MFC) with Profibus-DP Interface
EL-FLOW Select Mass Flow Controller (MFC) with Profibus-DP Interface

Characteristics

  • Baud rates from 9,6 kBaud up to 12 MBaud
  • +15 Vdc or +24 Vdc supply voltage
  • modular slave with max. 50 data modules
  • flexibility of data-configuration by selecting suitable modules
  • parameter-data setting by means of a configuration tool is supported
  • max. 244 Bytes input and max. 244 Bytes output
  • freeze and synchronization is supported
  • connection to PROFIBUS DP by means of Sub-D-9 connector
  • PROFIBUS DP slaves, using SPC3-chip, automatically adapt to baudrates determined by the master
  • station-address setting by microswitch on instrument
  • tooling software or PROFIBUS DP Master configuration software
  • galvanic isolation up to 500 V (for data lines)
  • connection of max. 124 instruments 1 bus
  • maximum bus length 1200 metres at 9,6 kBaud, 100 metres at 12 MBaud


PROFIBUS system example
afbeelding

Certificate

The PROFIBUS Nutzerorganisation e.V. granted Bronkhorst High-Tech B.V. certificates for their PROFIBUS Slaves MBC2 and MBC3.

PROFIBUS DP downloads

PROFIBUS Accessories
PROFIBUS DP GSD
PROFIBUS GATEWAY GSD
PROFIBUS DP manual

Bronkhorst USA inc.

57 South Commerce Way
Suite 120
USA - Bethlehem, PA 18017 
Tel.  +1-610-866-6750
[email protected]

     
Copyright © 2020 Bronkhorst. All rights reserved.     Sitemap     Disclaimer     Privacy note